Click the small black square in the bottom right corner of the field box and drag it UP as far as it will go.
I know, this is what I do, but my hand shaked like crazy to aim that small pixel for perfection... also, if i drag that black dot too far, it will become second line.. i dont want that... i want it stays one line only
is there anything i can click to make it do it by itself?
Set the zoom to 400% to make it easier to see. Then click the black square and move the mouse upwards until the field becomes a single line.
You can also use the inspector to change the height or width of a layout object one pixel at a time.
- Select it
- Go to the Position section of the position tab of the Inspector
- Click on the units to the right of the position boxes until you get px for pixel
- Change the height or width of the field by the desired number of pixels.
- Press tab or click another box in the section to see the dimensions of the selected layout object change.