1 Reply Latest reply on Dec 17, 2013 2:50 PM by philmodjunk

    Label format problem

    EugeneThorne

      Title

      Label format problem

      Post

           I am using Avery 5160 address labels and the addresses print a little low and some of them below and off the label. Any ideas.

        • 1. Re: Label format problem
          philmodjunk

               Either the body or a header layout part is too large and should be reduced by a pixel or two. You can make small adjustments to a layout part by clicking the label while in Layout mode and then specify a different Height in the Inspector's Height box. You can click the units to the right of these boxes to change them into points instead of inches or centimeters.