I have a couple scripts that go from my main data base to a 2nd and 3rd one to look up info then back.
The 2nd one works as it should, my employees can run the script, it goes to the 2nd data base, gets the info and comes back with out incident. The script is in three parts and i have each part set to run with full privileges.
I have the security set to read only.
On the 3rd data base, it asked each employee to enter the password each time. I triple checked each PW... they are the same one they use to log onto filemaker and the same one they use to log onto the 2nd one.
The scripts for the 3rd one are set to run with full privileges.
I had to switch the access to full access to prevent FM from asking for the PW.
I need to figure it out and reset it back to read only.