Tab key doesn't change field but acts like ctrl+tab
The previous version (6 or 7, can't remember) was working fine and the key TAB was used to change field.
Now, version 11.0v3, this key acts as Ctlr+Tab: it enters a TAB character in the field and doesn't move to the next one.
I searched arount for any preference or similar parameter, I searched also the existing posts in the forum but I couldn't find anything related (well... there were 8 thousands post to check... I stopped after about 100...)
(O.S. Windows Seven Professional 64bit)
Any help is appreciated
Tab should move you from field to field. Enter layout mode, select one of these fields and check the behavior section of Inspector's Data tab to make sure that Tab is selected in the "go to next object using" section.