I can make the page larger by grabbing on to the page and dragging it down
but I cannot make it smaller to 8.5" like I want to.
I have the Page Set up as Letter and horizontal but Its like its locked.
attached screen shot.
I built a new layout.
Fixed..I wish I could still have someone tell me why I could not adjust the page size
I know it cannot be locked in Layers
Filemaker Does not have Layers.
I guess I will Build another layout.
only PARTS can adjust height through the Inspector. You must click on the part: header, body, etc. (on the very left side - or at the bottom of the part). The height of the page is set through the Page Setup. You also are showing the page margins, which might be confusing you on the ability to resize the page. Hide those and send another screenshot.
I'll give that at go
Rebuilding the page worked.
But I want to understand
Thanks. I'll try
Sent from my iPhone
The size of the part will be limited to objects in the part. So, for example, if you have an object at around the 9" mark. You can't make the layout smaller than 9" vertically. If you move that object up, you will be able to move the bottom of the layout up also.
I'll check that
Thank you for your post!
beverly and jormond offered great advice. I'm also going to move this thread from the FileMaker Community Feedback Space, which is specifically for input on the Community itself, to the Discussions Space where you should receive more views and potentially more feedback on this topic!
Retrieving data ...