AnsweredAssumed Answered

On Panel Switch Question

Question asked by mbornhoe on Feb 14, 2017
Latest reply on Feb 14, 2017 by user19752

I am using an On Panel Switch event to send a user into find mode when clicking on a specific panel.  I use the Get ( TriggeredTargetPanel ) to detect if the desired panel was chosen then go to the named panel and run a sub-script that takes the user into find mode.  My problem is,  if the user clicks on another panel while in find mode the On Panel Switch event does not run again even though the event is enabled in browse and find mode.  Is this the expected behavior?

Outcomes