I am trying to use Filemaker as database source for OrCAD software.
I was able to do so by using ODBC but there are a couple of problems appear
1. Filemaker login prompt appear multiple times depending on the number of table existed in the database when i try to connect to the database from OrCAD.
e.g. If there are 5 tables in the database, Filemaker prompt me to log in 5 times.
2. If I close the OrCAD software and reopen it. it will fail to connect to the database. The error is ODBC error. Failed to connect to listener
I am trying to figure out this problem from both Filemaker and OrCAD sides.
I hope someone can at least point me to look in the right direction.
Thanks in advance