AnsweredAssumed Answered

Error after conversion from 6 - 11 - 17 "This record cannot be modified in this window"

Question asked by crbardsley on Jun 23, 2018
Latest reply on Jun 24, 2018 by Markus Schneider

After converting an old Filemaker 5 app to 11 and then 17, i get the following error at certain points in it.


"This record cannot be modified in this window because it is already being modified in a different window"

No matter where i put the commit line, i get the issue.


Here is one place (without the commit lines since they are not working). Any help would be greatly appreciated.


First Script

Enter Browse Mode Print Setup [ Orientation: Portrait; Paper size: 8.5" x 11" ] [ Restore; No dialog ]

Perform Script [ “PasteValidProcessFluids”]  <- Error first comes up on this one.

Set Field [ Master::PumpIDSelected; "" ]

Set Field [ Master::PumpDPTagSelected; "" ]

Set Field [ Master::PumpNumberinList; 0 ]

Perform Script [ “InitializePumpOptions” ]


Here is the PasteValidProcessFluids script.

Enter Browse Mode Go to Layout [ “AllFields2” (Master) ]

If [ IsValid(MatchShowProcessFluid1::Fluid)]

Set Field [ Master::Process Fluids; Master::ShowProcessFluid1 ]

End If <- Error comes up on this one and continues to come up.

If [ IsValid(MatchShowProcessFluid2::Fluid)]

Set Field [ Master::Process Fluid2; Master::ShowProcessFluid2 ]

End If

If [ IsValid(MatchShowProcessFluid3::Fluid)]

Set Field [ Master::Process Fluid3; Master::ShowProcessFluid3 ]

End If

If [ IsValid(MatchShowProcessFluid4::Fluid)]

Set Field [ Master::Process Fluid4; Master::ShowProcessFluid4 ]

End If If [ IsValid(MatchShowProcessFluid5::Fluid)]

Set Field [ Master::Process Fluid5; Master::ShowProcessFluid5 ]

End If


Thank you