On Entry into "Normal" button, it says "Choose a state for..."
When I go to choose, I get this.
The above screenshot in the original post, is from FMPA17
The below screenshot is from FMPA16.
Now it is this way in FMPA16 after appearing correct.
This has been reported before:
https://community.filemaker.com/message/752503 Can't Set Button Hover Style
https://community.filemaker.com/message/746424 Inspector: Layout Object Status Drop Down Issue
https://community.filemaker.com/thread/173640 FileMaker 16 Inspector bug
You may post a link to this thread on the Report A Product Issue thread(s) to get the attention of @TSGal or @TSPlatypus (our tech support on this forum). If any resolution is available, they can point you to the latest updates.
Thank you for your posts.
As Beverly pointed out (Thank you!), our Development and Testing departments are aware of this issue under the Windows operating system. I have attached your post to the original report. When more information becomes available, I will post again.
Retrieving data ...