AnsweredAssumed Answered

How do I send a command to a TSC label printer on the network?

Question asked by ReidLarson on Dec 15, 2018
Latest reply on Jan 2, 2019 by ReidLarson

I have a TSC TA210 on the LAN. TSC's language is TSPL, which has a manual found here. The printer's spec sheet also says it supports ZPL through emulation.

 

I've successfully used TSC's diagnostic tool to send TSPL commands to the printer. However, I can't find any instructions on sending the commands from other sources. I tried running Wireshark to capture what the diagnostic tool was sending, but my limited understanding of it didn't provide much insight.

 

I don't deal with printers in this way very often, so perhaps there's some standard way of sending commands to them that I just don't know about.

Outcomes