0 Replies Latest reply on Dec 15, 2012 11:13 AM by chuckburr

    Labels not kissing, creep

    chuckburr

      I am trying to get labels with pictures two-columns to print kissing on an 8.5 x 11" Avery 5390 sheet. However, it appears you cannot create a body that is 2.5" tall that holds a container field that is 2.5" tall. There is always this one pixel boarder. See the first screen shot, the boarders of the body top, botton, and left are outside the container field so there is a one pixel creep vertically. This results in the second screen shot of a couple pixel gap between the pictures creeping down the page resulting in quite a problem by the last row of picture labels. One solution would be to reduce the size of the container field below 2.5" and move the body up one pixel so the creep ends. Does anyone know of a way though to put a 2.5" field on a 2.5" body so there is no one pixel boarder creep?

       

      Thank you,

       

      Chuck Burr

      Restoration Seeds

      Ashland, Oregon