I have a report with a trailing sub-summary that has sliding objects on it. After the update to v4 both FMP and FMA the objects don't slide.
anyone else seeing this?
I have a report I tested and it is working for slide up based on all above. v4, windows 7, FMA
This report has been working fine until the v4 update. Ok what I discovered is sliding objects are a bit more pickey!
The Line and total in the sub-summary section failed to slide up because the line was touching the portal causing the line and total not to slide up. moving the line down a few pixels, i mean pts, solved the problem...
Thanks Mike…I did figure out the problem, I guess I have been putting sliding objects a bit to close
Pueblo Systems, Inc.
I've run into that before too, I wish there was an easier way to indicate what an object "collides" with, IE if you mouseover a selected object in layout mode, it's collisions are marked with red X's. That would certainly make troubleshooting a bit easier.
Interesting and worrisome though that the jump from 12.3 -> 12.4 caused an issue.
I did just move this system from FM 11 to FM 12v3.
It is entirely possible that they haven't run this report until after the v4 update. So I might have been a bit premature is saying this was from the v4 update...
Sent from my windows 8 phone
Retrieving data ...