1 Reply Latest reply on Aug 24, 2014 1:00 PM by jbante

    SetPrecision Question


      I have a field that I would like to limit the precision to the tenths decimal place (i.e. 100.1). I was planning to use SetPrecision to do this, but it appears to not be working.


      The field (we'll call it "Field A") is a number and is a global, it is populated via a script. To attempt to control the precision I set it as an Auto-Enter Calculation (allowing existing values to be replaced). The calulation is as follows: SetPrecision (FieldA ; 1).


      Yet when I adjusted the settings nothing changed. I also refired the script and nothing changed. (I am still getting a result with too much precision 28.1188119).


      Am I following the correct process here? Am I missing a step?